Issue: 08/2012
» Film gate cooling unit (option)
» Water cooling system (from 4000 W lamp capacity on)
» Automation system (option)
- DMP 1 Digital Matrix Programmer
- CCA3 Cue Code Automation
- SA2 Sequence Cinema Automation
- EMK 1 Electronic Automation System
» Pedestals
» Reader for DOLBY / DTS / SDDS (option)
» Rectier
- Standard rectier
- 65 to 85 A
- 75 to 95 A
- 100 to 140 A
- Kinoton rectier
- KEX 110 E (up to 110 A)
- KEX 170 E (up to 150 A)
» Film cleaner (option)
» Operating manuals
U The projector will be delivered completely wired and factory tested.
U Only use suitable hoisting machines (crane, fork-lift).
U Do not use unit parts as climbing aid.
U The electrical connections have to be in accordance with local regulations and be
installed professionally.
U All installation should only be carried out by Kinoton service.
» The place on which the unit will be installed must be even, solid and clean.
» The gure on the next page shows the projector’s dimensions.
» Requirements of the projection room:
- humidity: 40 to 60 %
- temperature: 15 to 25° C
- maximum sea level: 2000 m
To Next Page
Loading...
