Issue: 06/2011
• Put the protection coat over the bulb -
thread the anode cable through the coat
opening and shove the protective coat to
the bulb’s socket such the coat slits slide
over the socket’s pin.
• Unscrew the bulb by turning the protective
coat.
• Pack the used xenon bulb as shown in
gures.
• Open the protective coat cap of the new
xenon bulb and screw the bulb in its pro-
tective coat into the lamphouse socket.
• Remove the protective coat and connect
the anode cable to the lamphouse socket.
• Close the lamphouse door.
To Next Page
Loading...
