Issue: 08/2012
• Thread the lm into the lm gate and close the lm pressure skate.
One whole frame must be centered vertically in front of the aperture opening.
There is a small light inside the aperture to assist in centring.
Assure the lm is centered horizontally between the ceramic discs.
• - Open the sprocket pad shoe.
- Thread the lm into the combined holdback/bottom sprocket (all perforations engage
in the sprocket teeth).
- Close the pad shoe.
- Verify the loop below gate is still OK
• Thread the lm via the guide rollers to the take-up friction and wind-up the lm sev-
eral times around the take-up reel or lead the lm to “take-up” level of platter system..
If the projector was switched off with a threaded lm the lm loops and the lm position
must be checked again.
X
Z The xenon lamp will be switched on when the lm is running forwards (DIP 7 is
OFF).
If DIP 7 is ON the xenon lamp will ignite at the rst projector start and will get off
when projector is switched off.
Z The dowser will be open when projection speed is more than zero.
Z All switching and direction changes are to be done when projector is off.
Start forwards
Press “in” selects 25 fps (factory-set) - press “out” selects 24 fps (factory-set)
Stop the forward or optional reverse running
Start reverse (optional for projectors with reverse running unit)
Select 24 fps or VARIA speed (optional)
To Next Page
Loading...
