Issue: 08/2012
Ceramics roller Remove the ceramics rollers and then remove the dirt in the
holes by using air pressure. Clean the ceramics roller with a
alcohol moisturized cloth.
Film break sensor Clean the lm break sensor with a soft cloth.
Main drive motor / fan Blow out the dust with pressurized air.
Guide rollers Clean the guide rollers and roller shafts with alcohol.
Spool shafts Lubricate with Esso universal oil.
Shutter /
shutter housing
Clean the shutter housing with pressurized air.
Clean shutter edges with a soft toothbrush.
Lens holder Lubricate the lens holder guidance with Cardan oil,
type 8657
Reverse-scan sound
device
Check O-rings on sound pressure roller.
Check all rollers, whether they run easily.
To Next Page
Loading...
