Issue: 08/2012
• Push switch “in” on both FP 75 E projectors (provided the projectors are
coupled with one another), to activate the change-over function.
• The dowsers of the two projectors open or close alternatively.
• The change-over projection can be started on any projector.
• Switch off the projector.
• Position
70 mm
35 mm
to the desired format.
• Switch on the projector.
X
Z You cannot switch at a running projector.
Z If a format is selected at powered-on projector it is necessary to switch off the
projector and then switch on again for activating the new format.
To Next Page
Loading...
