Troubleshooting110 111
Fault Possible causes and rectification
The SP600 cleans edges
insufficiently.
It is possible that the cleaning cloth has not been fixed
properly.
• Check whether the cleaning cloth is straight and
firmly fixed on the cloth holder.
It is possible that the cleaning cloth was not washed
prior to first use.
• Wash the cleaning cloth prior to first use as de-
scribed in the chapter on “Cleaning the Kobold
MF600 cleaning cloths” on page 69.
It is possible that the cleaning cloth is too dry.
• Check the LED wave symbol on the SP600. If they
are lit up yellow, you need to fill the tank as
described in the chapter on “Removing, filling and
inserting the tank” on page 57.
• Apply moisture to the cleaning cloth using the func-
tion key as described in the chapter on “Single appli-
cation of moisture to a dry cloth” on page 63.
• You can also increase the moisture setting, if re-
quired, using the function key as described in the
chapter on “3.4.8 Automatic application of moisture
and dry mode” on page 61.
A dirt film remains on the floor. It is possible that the cleaning cloth is soiled
excessively.
• Change the cleaning cloth as described in the chap-
ter on “Removing and replacing the Kobold MF600
cleaning cloth” on page 68.
To Next Page
Loading...
