REMOVING, FILLING AND INSERTING THE TANK
WARNING
Risk of electric shock!
• Always switch the device off and disconnect
the mains plug before all retrofitting, cleaning
and maintenance work.
NOTE
Risk of damage from improper use!
• Avoid forced insertion and extraction of the
tank.
For wet cleaning, moisture is applied to the cloth
from the tank in the SP600.
1. Remove the tank from the SP600. To do this,
gently pull up the green tank release mechanism
at the back of the SP600
and pull the tank
backwards to lift it out.
2. Unscrew the tank cap
.
3. Fill the tank cap with Koboclean as far as the
line (3ml)
.
4. Pour this quantity into the tank .
5. Fill the tank with fresh tap water to the maxi-
mum mark
.
6. Put the cap back onto the tank and do it up.
7. Insert the tank into the SP600. This is done by
first pushing the front of the tank into the
SP600
and then pressing the back of the tank
into its holder
.
You will hear the tank snap into place.
1
2
3
5
6
7
4
To Next Page
Loading...
