106
The KARMA function does not start playing
• Is the [ON/OFF] key on (lit)?
• If the KARMA module does not start playing in
Combination, Sequencer, or Song Play mode, has
“Run Check Box” been checked? Also, are the
“Input Channel” and “Output Channel” settings
appropriate?...................
☞p.83, PG p.58, p.104, p.123
• Is the GLOBAL 2.1: MIDI “MIDI Clock” set to
Internal?............................................................PG p.137
RPPR does not start
• Is the SEQ 1.1: Play/REC “RPPR” setting checked?
..........................................................................
☞PG p.71
• Are “Assign,” “Pattern Select,” and “Track” set
correctly?
........................................................
☞p.70, ☞PG p.93, 94
• If the GLOBAL 2.1: MIDI “MIDI Clock” parameter
set to Internal? ............................................
☞PG p.137
In Song Play mode, a GM/GS/XG-compatible SMF
is not played correctly
• Execute “GM Initialize” to initialize the settings.
........................................................................
☞PG p.116
• Is GLOBAL 1.1: System, Preference page “Bank
Map” set to GM(2)? ....................................
☞PG p.136
• Is S.PLAY 3.1: ParamStatus/Scale, Param…8 or
Param…1 page “Status” set to INT or BTH?
...............................................................
☞p.74, PG p.120
Settings for oscillator 2 are not displayed
• Make sure that the PROG 2.1: Ed–Basic, Prog Basic
page “Mode (Oscillator Mode)” parameter is set to
Double. ...................................................
☞p.46, PG p.7
This instrument does not respond to incoming MIDI
data
• Are all MIDI cables connected correctly?
...............................................................
☞p.13, PG p.245
• Is the MIDI data being received on the channel on
which it is being transmitted? ...................
☞PG p.137
This instrument does not respond correctly to
incoming MIDI data
• Are the GLOBAL 2.1: MIDI settings “Enable
Program Change,” “Bank,” “Ctrl Change,” and
“AfterT” each checked? ............................
☞PG p.138
• If you wish to receive MIDI exclusive messages, is
the GLOBAL 2.1: MIDI “Exclusive” item checked?
........................................................................
☞PG p.139
• Does this instrument support the types of messages
that are being sent to it?
Can’t format a floppy disk
• Are you using a 2.5 inch 2HD or 2DD floppy disk?
• Is the floppy disk inserted correctly?
• Cover the write protect hole of the floppy disk, so
that it is in the “write permit” position.
Correctly insert a 3.5 inch 2HD or 2DD floppy disk
(with its write protect hole covered) into the disk
drive, and format it once again.
Can’s save/load data to/from a floppy disk
• Is the floppy disk inserted correctly?
• Is the floppy disk formatted?
• Is the write protect hole of the floppy disk covered,
so that it is in the “write permit” position?
Correctly insert a 3.5 inch 2HD or 2DD floppy disk
(with its write protect hole covered) into the disk
drive, and perform the save or load operation once
again.
To Next Page
Loading...
Need help?
General
