Korg Karma - Restoring the Factory Settings; Loading the Preload Data

43
Basic functions
Restoring the factory settings
Restoring the factory settings
Loading the preload data
The factory setting data is referred to as the “preload
data”, and you can restore the factory settings for this
instrument’s programs, combinations, and global set-
tings by loading this preload data.
This will rewrite any data that had been written
before loading. If you do not wish to lose this data,
you must first save it on a floppy disk (☞p.40).
1 Insert the included KMFD-00P floppy disk into the
floppy disk drive.
For details on floppy disk handling, refer to “Disk
mode” (☞p.95).
2 Press the [DISK] key to enter Disk mode.
You will enter Disk mode.
3 Press the [F1] (“Load”) key.
File information will be displayed in the Load page.
4 Use the cursor keys [ ], [ ] to select “PRE-
LOAD.PCG.”
It will be highlighted.
A .PCG file contains programs, combinations, drum
kits, and global setting data.
5 Press the [F8] (“UTILITY”) key, choose the “Load
selected” utility menu command, and press the
[F8] (“OK”) key.
A dialog box will appear
6 If “Load PRELOAD.SNG too” is checked when
you load, the .SNG file will also be loaded when
the .PCG file is loaded.
7 Press the [F8] (“OK”) key, and loading will be exe-
cuted.
Never remove the media while data is being
loaded.
If the “Memory Protected” dialog box appears,
uncheck memory protect, and try the loading oper-
ation once again. (☞p.38)