14
Basic operation
Selecting modes, pages and tabs;
setting parameters
1. Selecting modes
● In order to use a particular function on the
KARMA, you must first select the appropriate
mode. Press one of the front panel mode keys
([COMBI] key – [DISK] key) to enter the corre-
sponding mode.
2. Selecting pages and tabs
Each mode has a large number of parameters, which
are grouped into pages. Each page is further divided
into as many as seven groups. These are referred to as
“tabs.”
Selecting a page
1 Make sure that the desired mode is selected.
To select a mode, press the appropriate mode key
([COMBI] – [DISK]). Here we will use Combination
mode as an example for our explanation. Press the
[COMBI] key.
2 Press the [MENU] key.
The page menu will appear.
In Disk mode there is only one page, so the page
menu will not appear.
3 Press the function key [F1]–[F7] that is nearest the
page you wish to select.
If multiple pages are assigned to one function key,
press the same key to move the cursor downward.
You can also use the [ ], [ ], [ ], [ ] cursor keys to
move.
4 Press the [F8] (“Open”) key.
When you press the [F8] key, you will jump to the
selected page, and that page will appear.
As an example here, press the [F3] key three times to
select “KeyZ,” and then press the [F8] (“Open”) key.
The 3.3: Ed-Key Zone page will appear.
You can also use the following alternative methods
to select a page.
• Press the [MENU] key, and then use the [ ] [ ]
keys to move forward or backward through the
pages in the order of 1.1→2.1→2.2→2.3 etc.
• Hold down the [MENU] key, and use numeric keys
[1]–[7] to enter a two-digit page number to move
directly to the corresponding page. (To select the
page shown above, you would press [3], [3].)
If only one page is assigned to each function key
(group), as in COMBI 1.1: Play or the pages of
Global mode, the first digit of the numeric key [1]–
[7] will move to the corresponding page.
The page selected at this time will be the page that was
last selected. If there is no corresponding page, nothing
will happen.
When you press the [EXIT] key, you will return to
1.1 from any page.
Selecting a tab
5 Press the function key [F1]–[F7] that is nearest the
tab displayed at the bottom of the LCD screen.
As an example, we will select the “Review” tab.
Press the [F5] key.
Some pages have no tabs.
6 To move to another page, press the [MENU] key
and repeat the procedure from step 3.
[COMBI] key: Combination mode
[PROG] key: Program mode
[SEQ] key: Sequencer mode
[S.PLAY] key: Song Play mode
[GLOBAL] key: Global mode
[DISK] key: Disk mode
To Next Page
Loading...
Need help?
General
