01/FORK, TRIPLE CLAMP 22
– Grease and push on seal ring .
Lubricant (T511) ( p. 206)
Info
Sealing ring downward, open side upward.
– Push on support ring .
– Remove the special tool.
200670-10
– Sand the edges of the sliding bushes with 600-grain sandpaper, then clean and
grease them.
Fork oil (SAE 5) ( p. 205)
200671-10
– Push on the lower sliding bushing .
– Mount the upper sliding bushing .
Info
Without using tools, carefully pull the stack apart by hand.
200672-10
– Push on the outer tube.
– Heat up the outer tube in area of the lower sliding bushings.
Guideline
50 °C (122 °F)
– Hold the lower sliding bushing with the longer side of the special tool.
Assembly tool (T1402S) ( p. 218)
– Press on the outer tube as far as it will go.
200673-10
– Position the support ring.
– Hold the seal ring with the shorter side of the special tool.
Assembly tool (T1402S) ( p. 218)
– Press on the outer tube as far as it will go.
200656-11
– Mount lock ring .
Info
The lock ring must engage audibly.
To Next Page
Loading...
