01/FORK, TRIPLE CLAMP 23
200655-11
– Install dust boot .
200674-10
– Grease the O-ring of valve of the rebound damping.
Lubricant (T158) ( p. 206)
– Mount valve of the rebound damping with the spring on adjusting tube .
– Mount valve of the rebound damping from below in cartridge .
The adjusting tube protrudes 5 mm from the cartridge and can be pressed in
against the resistance of the spring.
The adjusting tube protrudes more than 7 mm from the cartridge and cannot
be pressed in against the resistance of the spring.
– Screw on fluid barrier as far as it will go.
Info
The fluid barrier must be tightened as much as possible. Do not use tools.
200675-10
– Install the special tool on the cartridge.
Gripping tool (T14026S1) ( p. 218)
Info
The special tool must be used to prevent the adjusting tube being lifted and
thus to prevent oil from reaching the piston rod.
200683-10
– Push the cartridge with the spring seat and preload spacer into the inner tube.
– Mount screw of the cartridge with the seal ring and tighten it.
Guideline
Cartridge screw M12x1 25 Nm
(18.4 lbf ft)
200682-10
– Grease and mount screws of the axle clamp but do not tighten.
Lubricant (T152) ( p. 207)
To Next Page
Loading...
