KTM 2008 690 SMC EU - Page 93

30/ENGINE 91
300223-11
– Install the screw and nut  of the lower engine bracket, but do not tighten them
yet.
300222-10
– Remove the floor jack with the special tool.
Floor jack attachment (75029055000) ( p. 215)
300221-11
– Position the engine bearer.
– Mount and tighten screws .
Guideline
Screw, engine bearer on frame M10 45 Nm
(33.2 lbf ft)
– Mount and tighten screw  with nut.
Guideline
Engine carrying screw M10 45 Nm
(33.2 lbf ft)
Loctite
®
243™
– Tighten the swingarm pivot.
Guideline
Screw, swingarm pivot M12x1.75 80 Nm (59 lbf ft)
– Tighten the lower engine bracket.
Guideline
Engine carrying screw M10 45 Nm
(33.2 lbf ft)
Loctite
®
243™
300220-11
– Position the hoses of the engine breather, the SLS and the oil return line. Mount
the spring-loaded band-type clamp  using the special tool.
Pliers for spring-loaded band-type clamp (60029057100) ( p. 210)
300219-11
– Attach the spark plug connector.
– Plug in the connector of the engine coolant temperature sensor .