KTM 2008 690 SMC EU - 30;DISASSEMBLING THE ENGINE; Draining the engine oil

30/ENGINE 92
300218-11
– Reconnect plug connectors  of the gear position sensor, the crankshaft position
sensor and the alternator.
300217-11
– Position the throttle valve body.
– Position and tighten hose clip .
300216-11
– Position the electrical connection  on the starter motor. Mount and tighten screw.
Guideline
Screw, starter cable on starter M5 3 Nm (2.2 lbf ft)
– Position the ground wire on the starter motor. Mount and tighten screw .
Guideline
Screw, starter motor M6 10 Nm
(7.4 lbf ft)
Loctite
®
243™
300214-11
– Insert the clutch push rod.
– Position the clutch slave cylinder.
– Mount and tighten screws .
Guideline
Screw, clutch slave cylin-
der
M6x20 10 Nm
(7.4 lbf ft)
Loctite
®
243™
Screw, clutch slave cylin-
der
M6x35 10 Nm
(7.4 lbf ft)
–
– Mount the engine sprocket with the chain.
– Position the new lock washer and mount nut  but do not tighten yet.
300215-11
– Position the rear wheel.
– Mount the chain adjuster and nut.
– Push the rear wheel forward so that the chain adjusters are on the tensioning
screws, and tighten the nut .
Guideline
Nut, rear wheel spindle M25x1.5 90 Nm
(66.4 lbf ft)
300214-12
– Have an assistant operate the rear brake.
– Tighten the engine sprocket nut.
Guideline
Nut, engine sprocket M20x1.5 60 Nm
(44.3 lbf ft)
Loctite
®
243™
– Secure the nut with the lock washer.