ExpressionMate ROM Setups
Setup Descriptions
120
20. Toggle Split - Section 1 plays notes in zone 3, Section 2
controls Arp note duration in zone 3. Section 3 controls tempo.
Map2 sends expression to Zone 3, Map 3 crossfades pan for
zone 1 and 2.
21. CCNotRhyTogl - Notes played are toggled into the Arpeg-
giator using notes played from ribbon section 1. Section 2
changes the Arp shift amount and section 3 changes Arp shift
limit. Press SW1 to stop arpeggiation.
22. PlayHold/SW1 - Play notes and hold them and press SW1.
23. C2Drms 3/4B - Play C2 to start Arp pattern. Play with Sw
and Pedals. They turn on and off part of the pattern. Play notes
on Section 2; control Arpeggiator speed on Section 3.
24. BoomBeBoomBe - Drums everywhere. Sounds on all rib-
bon section, SW and SP controllers. The Arp plays different
patterns across the key splits. Map3 controls the note switch to
enable notes to be played from the CCPD.
25. MIDI Volume - Sends volume on one channel up the rib-
bon.
26. XG Snd Cntrl - Sends channel-based sound modiļ¬cations
to XG sound modules. RBN1 sends controller #71 which is fre-
quency cutoff and centers at 64, lower values being darker and
higher values being brighter. RBN2 sends controller #74 which
controls resonance. RBN3 sends controller #72 which adjusts
the release time. The CCPD sends controller #73 which adjusts
the attack time. Breath sends controller #2 Breath; SP1 sends
controller #68 soft pedal; SP2 sends controller #66 Sostenuto.
27. XG Efx Cntrl - Sends controller information to effects on
XG sound modules (similar to XG Snd Cntrl, above). RBN1
sends controller #91 which is effect send 1, RBN2 sends #93
effect send 2, and RBN3 sends #94 effect send 3, the CCPD
sends controller #16 which adjusts the assignable effect control-
ler when the Variation is in INS (often controls the Wet/Dry
amount or something like distortion level.)
To Next Page
Loading...
