Kurzweil PC3LE - Tempo

Setup Mode
The Setup Editor
7-63
Send Levels and Pre/Post Ins.
Therearetwoparametersforeachofthesetuporsong’s16availableMIDIchannels:SendLevel
(toprow)andPre‐/Post‐Insert(bottomrow).ThesettingfortheparameterSendLeveldetermines
iftheAuxSendLevelfortheselectedzone/MIDIchannel’sprogramisoverridden,andifso,
by
whatvalue.Thedefaultvalueof[p]means“no override”(i.e.,usethevaluesspecifiedinthe
program.)Tooverridethesendlevelvalue,selectthesendlevelparameter(thetoprow)forthe
desiredchannel,andenteranewvaluewiththeAlphaWheel,‐/+buttons,orentera
valuewith
alphanumericpadandpresstheEnterbutton.
ThesettingfortheparameterPre‐/Post‐InsertdeterminesifthecurrentAuxroutingforthe
selectedzone/MIDIchannel’sprogramisoverridden,andifso,bywhatrouting.Thedefault
valueof[p]means“nooverride”(i.e.,usethevaluesspecifiedin
theprogram.)Tooverridethe
Pre‐/Post‐Insertparametersetting,selectthePre‐/Post‐Insertparameter(thebottomrow)forthe
desiredzone/track,andchangethevaluewiththeAlphaWheelor‐/+buttons.Premeansthat
theAuxSendtakesplacebeforeanyInsertEffectisapplied,whereasa
settingofPstmeansthat
theAuxSendtakesplacepost‐InsertEffect.(Ofcourse,iftheprogramonthechannelhasno
InsertEffectsloaded,thenthisparameterwillmakenodifference.)SeeSignalFlow on page 7‐60
fordetailsonpre‐andpost‐InsertAuxEffects.
The COMMON Page
TheCOMMONpagecontainsparametersthataffecteveryzoneinthecurrentsetup.
Tempo
WhenClockSourceissettoInternal,theTempoparametersetsthePC3LE’ssystemtempo.The
TempoparametervaluesareinunitsofBPM(beatsperminute).Thiscontrolsthetempoofany
arpeggiatorsusedinthecurrentsetup,anyriffsthathavetheirBPMparametersettoSetup,any
tempobasedeffects,andthecurrentlyselectedsonginSongmode.Youcanalsosetthetempo
usingthetaptempobutton(locatedonthefrontpanelbelowtheModebuttons.)TaptheTap
Tempobuttononbeatforameasureortwoatthedesiredtempotosetatempo.
Thisalsobrings
uptheTapTempopage(see
Tap Tempo Button on page 7‐4.)
Parameter Range of Values Default
Tempo 20 to 300 120
Clock source Internal, External Internal
ArpGlobal (Arpeggiator Global) Off, Arp 1 to 16 Off
Aux FX channel 1 to 16 1
KB3 Channel 1 to 16 1