Kurzweil PC3LE - The ARPEGGIATOR 1 & 2 Pages (ARP 1, ARP 2); The Program Editor Utility Soft Buttons

Program Mode
The Program Editor
6-15
Note: ThoughauxeffectsChainsarestoredforeachprogram,onlyonechannelatatime(the
currentlyselectedchannel)canuseitsauxeffectsChainontheauxbus.AuxeffectsChainson
otherchannelsaremadeinactive.
The ARPEGGIATOR 1 & 2 Pages (ARP 1, ARP 2)
Eachprogramhasitsownarpeggiatorsett ings.PresstheARP1orARP2softbuttontogoto
oneofthetwopagesofarpeggiatorsettingsforthecurrentprogram.(Youcanalsoviewandedit
thesesettingsfromtheProgrammodemainpagebypressingtheArpSettingsbutton
onthefrontpanel,
belowthemodebuttons.)
SeeChapter 7,TheARPEGGIATORPageformoreonthesesettings.ThearpeggiatorinProgram
modeactsthesameasasinglearpeggiatordoesinSetupmode,butinProgrammodethe
Arpeggiator2pagehasnoSyncTo,SyncType,orNumBeatsparameters
asitdoesinSetup
mode.
The Program Editor Utility Soft Buttons
Import Arpeggiator Settings (ImpArp)
TheImpArpbuttonallowsyoutoimportarpeggiatorsettingsfromotherprograms.Pressing
theImpArpbuttonbringsyoutotheImportArppage.OntheImportArppage,selectaprogram
fromthelistandpresstheImportsoftbuttontoimportthearpeggiatorsettingsfromthe
selectedprogramtothecurrent
program.
Delete
Thiserasesaprogramfrommemory,freeingupspacetostoreprogramsinotherlocations.(You
cancheckthefreememoryinthePC3LEatanytime,onthe toplineoftheMastermodepage.)
PressDelete,andyouwillbegivenachoicetoDeleteorCancel.
PressDeleteagain,andan“Are 
YouSure?”messagewillappear.PressYestodeletethesetup,orNotocancel.
Ifyoudeleteausereditedprogram,thereisnowaytorecoverit.Ifyoudeleteanedited
programthathasbeensavedoverafactoryROMID#,the
originalfactoryROMprogramwillre‐
appear.Fa ctoryROMprogramscannotbedeleted.