Kurzweil PC3LE - Bank Select

9-20
Master Mode
MIDI Receive (RECV)
All Notes Off
Ifthisparameter’svalueissettoNormal,thePC3LErespondstoAllNotesOffmessages
receivedoverMIDI.Ignorecausesthesemessagestobeignored.Ifyou’reusingaRoland
productasaMIDIcontrollerforyourPC3LE,you’llwanttosetthevalueofthisparameterto
Ignore.
ThisisbecausesomeolderRolandproductsoccasionallysendanAllNotesOffmessage
whennokeysarehelddown—evenifyou’ resustainingnoteswithapedal.Youmightfindall
yoursustainsmissingfromyoursequence,forexample,ifyou’redrivingyourPC3LEfromone
ofRoland’shardwaresequencers.
SettingthisparametertoIgnoretakescareofthisproblem.
Regardlessofthesettingforthisparameter,thePC3LEalwaysrespondstoitsownPanicbutton
byshuttingoffallactivenotesandcontrollers.
Program Change Mode (PrgChgMode)
ThisdetermineshowthePC3LErespondstoprogramchangecommandsreceivedviaMIDI.See
ProgramChangeFormats on page 9‐25foranexpla nation ofthevariousvaluesavailableforthis
parameter.
System Exclusive ID (SysExID)
TheSysExIDparameterdifferentiatesbetweenmorethanoneMIDIdeviceofthesamemodel. 
Youwon’tneedtochangethedefaultsettingof0unlessyouhavemultiplePC3LEs(orPC3’s,
K2600s,K2500s,orK2000s)receivingSysExmessagesfromasinglesource.Inthatcase,make
sureeachinstrumenthasa
differentSysExID.ThenyoucandirectSysExmessagestothe
appropriatePC3LEwiththeSysExIDbytethat’sincludedwitheverySysExmessage.Avalueof
127specifies“OmniReceive.”Thatis,atthisvalue,aPC3LE respondstoaSysExmessage
regardlessoftheSysExIDofthemessage.
Bank Select
BankSelectallowsyoutochoosebetweenhavingthePC3LErespondtoController0 or
Controller32orboth.Thereasonforthisisthatvariousmanufacturershavechosenonemethod
ortheother.Thethreepossiblevaluesforthisparameterare:
Ctl0 Respondstocontroller0only.
Ctl32 Respondstocontroller
32only.
Ctl0/32 Respondsto0or32.