TracPhone V7-HTS User’s Guide
83
Network Configuration
Wireless Settings
With Wi-Fi enabled, vessel devices can connect to the ICM via its built-
in wireless access point (WAP) and receive IP addresses from the ICM
via DHCP.
Figure 7-15 Wireless DHCP (Example)
NOTE: If the optional CommBox software is enabled, the Network Settings
page of the ICM/mini-VSAT Manager will not contain any configurable
fields.
To enable and configure the ICM’s Wi-Fi connection, follow these
steps:
1. At the TracPhone V7-HTS web interface, click the Settings tab.
Then click Network Settings.
NOTE: You can also change the ICM’s Wi-Fi settings at the mini-VSAT
Manager (www.mykvh.com). Go to the ICM > Network Configuration
section of the Vessel Details page and select Wi-Fi Settings.
2. In Wireless Settings, click Edit.
3. If the Login window appears, log in with the Administrator
password.
Important!
The range of the ICM’s WAP will depend on the layout and structure
of the vessel. For example, wireless signals degrade when passing
through bulkheads and near metal masses. If the system is installed
on a steel vessel, you might need a special WAP and the services of a
technician with advanced networking expertise.
Mobile
Devices
192.168.6.103
192.168.6.102
ICM
Wi-Fi
To Next Page
Loading...
Need help?
General
