Installing and Setting up the Machine > Embedded Web Server RX
113
4
Configure the settings.
Enter "SMTP" and "E-mail Send Settings" items.
SMTP
Set to send e-mail from the machine.
[SMTP Protocol]
Displays the SMTP protocol settings. Check that [SMTP Protocol] is set to [On]. If [Off] is set, click
[Protocols] and set the SMTP protocol to [On].
[SMTP Server Name]
Enter the host name or IP address of the SMTP server. Be sure to enter the items.
[SMTP Port Number]
Specify the port number to be used for SMTP. The default port number is 25.
[SMTP Server Timeout]
Set the amount of time to wait before time-out in seconds.
[Authentication Protocol]
To use SMTP authentication, enter the user information for authentication.
[SMTP Security]
Set SMTP security. Set [SMTP Security] of "SMTP (E-mail TX)" on the "Protocols" page.
[Connection Test]
Tests to confirm the proper operation under the settings without sending an email.
[Domain Restrictions]
To restrict the domains, click the [Domain List] and enter the domain names of addresses to be allowed
or rejected. Restriction can also be specified by e-mail address.
To Next Page
Loading...
