2-26
Installing and Setting up the Machine > Energy Saver function
Energy Saver function
If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode,
which minimizes power consumption.
Sleep
Message display and all indicators on the operation panel will go out to save a maximum amount of power
except the Energy Saver indicator, and then the Energy Saver indicator is flashing. This status is referred to as
Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
To resume, perform one of the following actions.
âĸ Select any key on the operation panel.
Recovery time from Sleep Mode is as follows.
âĸ ECOSYS PA6000x/ECOSYS PA5500x: 25.0 seconds or less
âĸ ECOSYS PA5000x: 20.0 seconds or less
âĸ ECOSYS PA4500x: 15.0 seconds or less
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more
slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
âĸ 1 minutes (default setting)
To change the preset sleep time, refer to the following:
Sleep Timer (page 8-34)
Status (Sleep Level Set.)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card
cannot be recognized.
For more information on Status, refer to the following:
Status (page 8-34)
To Next Page
Loading...
Need help?
General
