2-46
Installing and Setting up the Machine > Command Center RX
Changing Device Information
1
Display the screen.
1 Launch your Web browser.
2 In the address or location bar, enter the machine's IP address or the host name.
Click in the following order to check the machine's IP address and the host name.
[Status] in the home screen > [ ] [ ] key > [Network] > [OK] key
3 Log in with administrator privileges.
4 From the [Device Settings] menu, click [System].
2
Specify the host name.
Enter the device information, and then click [Submit].
After changing the setting, restart the network or turn the machine OFF and then ON.
To restart the network interface card, click [Reset] in the [Management Settings] menu, and then
click [Restart Network] in "Restart".
To Next Page
Loading...
Need help?
General
