Kyocera FS-1920 - Removing the Separators

2FP/2FY/2FR
1-6-30
(1) Removing the separators
WARNING The separators are extremely hot immediately after the printer was running. Allow substantial period of time
until it cools down.
1. Remove and split the fuser unit. See page 1-6-
27.
2. Remove the upper exit guide while unlatching
three latches.
3. Remove the exit pulley.
4. Hold the separator upright and remove the
separator and the separator spring.
Figure 1-6-29 Removing the separators
Step 1
Step 2
Separator
Separator spring
Separator
Latch
Latch
Latch
Upper exit guide
Exit pulley