Kyocera FS-1920 - Removing the Thermistor and the Thermal Cutout

2FP/2FY/2FR
1-6-33
(4) Removing the thermistor and the thermal cutout
1. Remove and split the fuser unit. See page 1-6-
27.
2. Remove the heater lamp. See page 1-6-31.
3. Remove the heat roller. See previous page.
4. Remove one screw.
5. Remove the thermistor.
6. Remove two screws and then remove cord
plate.
7. Remove one screw and the heater wire
terminal.
8. Remove the thermal cutout.
Figure 1-6-32 Removing the thermistor and thermal cutout
Screws
Screw
Heater wire terminal
Thermal cutout
Thermistor
Cord plate