Kyocera FS-1920 - Removing the Sensor Board

2FP/2FY/2FR-2
1-6-24
(5) Removing the sensor board
CAUTIONS Draw the connector straight to remove. If you draw the connector while it is slanted, the receptacle may be
damaged.
1. Remove the drum unit. See page 1-6-10.
2. Remove the high voltage unit. See previous
page.
3. Remove two connectors.
4. Remove the high voltage unit cover.
5. Remove the sensor board while unlatching
two latches.
Figure 1-6-23 Removing the sensor board
High voltage unit cover
Sensor board
Latch
Latch
Connector
Connector
Connector
Connector
Receptacle
Receptacle