Kyocera FS-1920 - Paper Feeding System Operation; Paper Feeding System Components

2FP/2FY/2FR
2-1-1
2-1-1 Paper feeding system
The paper feeding system picks up paper from the paper cassette, MP tray, or if installed, the paper feeder PF-60, feeds
it in the printer and delivers in the output tray. Paper is feed at the precise timing in synchronization with data processing.
The paper feeding system finally delivers the printed page to either the face-down or face-up output tray as manipulated
by the user.
(1) Paper feeding system
The figure below shows the components in the paper feeding system and the paths through which the paper travels. The
sensors, clutches, solenoids, motor etc., are described in the following pages.
Figure 2-1-1 Paper feeding components
5
6
8
7
9
10
11
12
13
14
16
17
18
19
20
4
3
2
1
Paper from optional
paper feeder PF-60
or duplexer DU-61
15
1. Middle feed roller
2. MP tray feed roller
3. Guide pulley(s)
4. MP tray
5. Paper cassette
6. Feed pulley
7. Retard roller
8. Feed roller
9. Pickup roller
10. Upper registration roller
11. Lower registration roller
12. Transfer roller
13. Drum
14. Press roller
15. Heat roller
16. Exit roller
17. Exit pulley(s)
18. FD roller
19. Pinch roller(s)
20. Face-down output tray