Kyocera FS-1920 - Downloading the Firmware from the Parallel Interface

2FP/2FY/2FR
1-7-3
(2) Downloading the firmware from the parallel interface
This section explains how to download firmware data from the parallel interface. The printer system can automatically
recognize whether the data to be overwritten is for the engine firmware, the controller firmware or operator panel message
data.
CAUTION Downloading the controller firmware takes several minutes. Do not turn power off during downloading.
NOTE MS-DOS is required for a downloading from the parallel interface. The computer must be connected to the
printer with a parallel cable.
1. Turn power switch on.
2. At the DOS prompt, send the command to the printer that engages the printer in the supervisor mode.
3. Copy the firmware data to the printer. (See the flow chart below)
[System firmware ex. SB20KA8400.bcmp, Engine firmware ex. EB20KA002.x01, Operator panel message data ex.
dm2001.spa]
Message display
PC display
Self test
>Supervisor mode
Parallel waiting
>ECHO !R!UPGR'SYS';EXIT;>PRN
Power switch: On
>COPY/B SB20K8200.bcmp PRN
>COPY/B EB20KA002.x01 PRN
>COPY/B dm2001.spa PRN
S
E
M
1.
Start
2.
3.
Ready
To the next page
: System firmware
: Engine firmware
: Operator panel message data
S
E
M