Kyocera FS-1920 - Removing the MP Tray Paper Feed Unit; Removing the Engine Relay Board

2FP/2FY/2FR-4
1-6-13
1-6-8 Removing the MP tray paper feed unit, MP tray feed roller and retard holder (roller)
(1) Removing the MP tray paper feed unit
1. Remove the paper transfer unit. See page 1-6-4.
2. Remove the developer. See page 1-6-2.
3. Remove the three connectors.
4. Remove the engine relay board while
5. Pull the MP tray paper feed unit out while
unlatching two latches off of points (A).
unlatching the latches.
Figure 1-6-12 Removing the engine relay board
Figure 1-6-13 Removing the MP tray paper feed unit
Connectors
Connector
Latches
Engine relay board
MP tray paper feed unit
Latch
(A)
(A)
Latch