Kyocera FS-1920 - Removing the Drive Unit and Main Motor

2FP/2FY/2FR-2
1-6-25
1-6-11 Removing the drive unit and main motor
CAUTIONS Draw the connector straight to remove. If you draw the connector while it is slanted, the receptacle may be
damaged.
1. Remove the paper cassette and the paper
transfer unit. See page 1-6-4.
2. Remove the top cover/face-down output tray.
See page 1-6-7.
3. Remove the left and right covers. See pages
1-6-8 and 1-6-9.
4. Remove two connectors.
5. Remove three connectors of the drive unit.
6. Remove five screws and the ground wire
terminal.
7. Remove the drive unit from the frame unit.
Figure 1-6-24 Removing drive unit
Connector
Connectors
Connector
Receptacle
Receptacle
Screw
Ground wire terminal
Screws
Drive unit
Connectors