Kyocera FS-1920 - Removing the Heat Roller

2FP/2FY/2FR
1-6-32
(3) Removing the heat roller
WARNING The heat roller is extremely hot immediately after the printer was running. Allow a substantial period of time
until it cools down.
1. Remove and split the fuser unit. See page 1-6-
27.
2. Remove the heater lamp. See the previous
page.
3. Remove the separators. See page 1-6-30.
4. Remove the two C rings.
5. Pull up both bearings at the same time.
6. Remove heat gear Z36, bearings, heat R
bush, and heat L bush from the heat roller.
Figure 1-6-31 Removing the heat roller
Heat gear Z36
Bearing
Heat R bush
Bearing
Heat roller
Heat L bush
C ring
C ring