Kyocera FS-1920 - Page 41

2FP/2FY/2FR-6
1-4-5
Service items Description
Item Description
23 EEPROM error of each unit Bit 0: Ppaer feeder 1
(Hexadecimal)
Bit 1: Paper feeder 2
Bit 2: Paper feeder 3
Bit 3: Duplexer
Bit 4: Sorter
Bit 5: Bulk paper feeder
Bit 6: (Reserved)
Bit 7: Drum
25 Serial interface information RS2: RS-232C
24 Drum ID -
26 Drum sensitivity information -
Setting value (FRPO I4), Hexadecimal
27* Calibration table settings
28 Optional paper feeder information First 2 bytes
Bit 2 to 6: Paper feeder 1 to 5 (4 and 5 Reserved)
Bit 1: Cassette 1
Bit 0: MP tray
Bit 7: Duplexer
Bit 8: Bulk paper feeder
Bit 9: Envelope feeder
Bit 10 to 15: (Reserved)
Second 2 bytes
Bit 0: Face-up
Bit 1: Face-down
Bit 2: (Reserved)
Bit 3: Sorter
Bit 4 to 15: (Reserved)
29 Average print density (%) 2 digits of integer part and 1 digit of fraction part
(total print density from shipping from factory)
30 Operation panel message language PMSG command setting value (decimal)
31 Current temperature 0 to 80 °C
("-" = Humidity/temperature sensor is abnormal.)
32 Current humidity 5 to 100 %RH (in 1% increment)
34* MAC address -
2 to 6 bytes, 8 to 36 bytes, 94 to 95 bytes (total 32 bytes)
2 to 6 bytes, 8 to 36 bytes, 94 to 95 bytes (total 32 bytes)
-
-
-
33* Number of rebooting for vertical distortion
check
-
35 Media type attributes Media type 1 to 28 (14 to 20: Reserved)
36 SPD information (slot 1)
37* SPD information (slot 2)
38 Engine parameter setting
39 Drum serial number
40 Machine serial number
*
1
: FS-3820N/3830N models only.