2FP/2FY/2FR-2
1-5-3
Code Contents
Remarks
Causes Check procedures/corrective measures
Non-supported duplexer is installed
·Non-supported duplexer DU-60 is
installed
Paper feeder PF-60 [top] with wrong
firmware version is installed
·The code that identifies the firmware
version was out of range.
Paper feeder PF-60 [middle] with
wrong firmware version is installed
·The code that identifies the firmware
version was out of range.
Bulk paper feeder PF-8E with wrong
firmware version is installed
·The code that identifies the firmware
version was out of range.
Paper feeder PF-60 [bottom] with
wrong firmware version is installed
·The code that identifies the firmware
version was out of range.
Optional duplexer DU-61 side regis-
tration error
· Side registration home position error of
optional duplexer DU-61.
DU-60 is in-
stalled.
Wrong firmware
version is used
on the main
board in paper
feeder PF-60.
Wrong firmware
version is used
on the main
board in paper
feeder PF-60 or
bulk paper feeder
PF-8E.
Wrong firmware
version is used
on the main
board in paper
feeder PF-60.
Defective gate
array U7 on the
engine board
(KP-1081).
Improper installa-
tion between
printer and op-
tional duplexer, or
each optional
unit.
Defective har-
ness (S03022)
between engine
board and op-
tional unit inter-
face connector.
Improper connec-
tor insertion.
Defective optional
duplexer DU-61.
Replace duplexer DU-60 for DU-61.
Change the main board with the one hav-
ing the correct firmware in paper feeder
PF-60.
Change the main board with the one hav-
ing the correct firmware in paper feeder
PF-60 or bulk paper feeder PF-8E.
Change the main board with the one hav-
ing the correct firmware in paper feeder
PF-60.
Replace engine board (KP-1081). See
page 1-6-20.
Follow installation instruction carefully
again.
Replace harness (S03022).
Remedy.
Refer to the optional duplexer DU-61’s
service manual.
0550
0560
0570
0580
1200
To Next Page
