Kyocera FS-6020 - Installing Network Interface Card (Optional)

FS-6020
1-3-9
Figure 1-3-14
Figure 1-3-13
1-3-3 Installing network interface card (optional)
Procedure
1. Remove the two screws and then remove the
optional interface slot cover.
2. Insert the network interface card into the
optional interface slot.
3. Use the two screws to secure the network
interface card.
4. Connect the network cable (in the case of IB-
20 or IB-21E).
5. Perform the network setting. (See IB-2x quick
configuration guide.)
Screws
Screws
Network
interface
card
Optional interface slot
Cover
IB-20 10 Base-TX,100 Base-TX,10 Base2
IB-21E 10 Base-TX,100 Base-TX
IB-22 Compatible to IEEE 802.11b
Wireless LAN
Network interface card that can be installed
Part number Specifications Remarks
IB-22
Variable name Setting range
Setting items for wireless network interface card IB-22
Ad hoc/802.11 Ad hoc/
Infrastruccture/Automatic
Any string (up to 32 characters)
Depends on the setting range
available for the wireless NIC.
DISABLE/64 bit/128 bit
Hexadecimal setting (00-FF)
64 bits = 10 digits
128 bits = 26 digits
Wireless LAN Mode
SSID
Channel
Encryption(WEP)
WEP key
Network interface
card
Network cable