Kyocera FS-6020 - Chapter 2: Paper Selection; General Paper Guidelines and Specifications

FS-6020
1-5-24
(14)Image is partly
missing.
Causes
1. Paper damp.
2. Paper creased.
3. Condensation on drum.
4. Flawed drum.
Causes Check procedures/corrective measures
1. Paper damp.
2. Paper creased.
3. Condensation on drum.
4. Flawed drum.
Check the paper storage conditions.
Replace the paper.
Perform drum surface refreshing. (See page 1-4-6.)
Perform drum surface refreshing. (See page 1-4-6.) If the drum is
flawed, replace the process unit.
(13)Offset occurs.
Causes
1. Defective cleaning blade.
2. Defective fixing unit.
(12)Paper creases. Causes
1. Paper curled.
2. Paper damp.
3. Defective fixing pressure spring.
4. Defective paper separation in the fixing unit.
Causes Check procedures/corrective measures
1. Paper curled.
2. Paper damp.
3. Defective fixing pressure spring.
4. Defective paper separation in the fixing unit.
Check the paper storage conditions.
Check the paper storage conditions.
Replace the fixing pressure spring.
Check the separator of the fixing unit. (See page 1-6-23.)
Causes Check procedures/corrective measures
1. Defective cleaning blade.
2. Defective fixing unit.
Replace the process unit.
Replace the heat roller and the press roller. (See pages 1-6-21 and
22.)