FS-6020
1-7-5
(4) Downloading the message data
To download the new message data, progress the following procedures.
1. Turn OFF the power supply switch to the
printer and computer.
2. Connect the parallel printer cable between
the computer and printer.
1. Turn ON the power to the printer.
2. Check that the message indication 1 is
indicated.
3. Input the command 2 following the DOS
prompt indication.
* Enter BOOST’SPR’ in capitals.
4. Check that the message indication 3 is
indicated.
5. Input the command 4 following the DOS
prompt indication and copy the message data
file to the printer (e.g.; dm9602.spa).
6. The message indication 5 is indicated while
downloading the data file. When the message
indication 6 is indicated, which shows the
end of downloading, turn OFF the power
switch once and then turn it on again.
7. Check that the message indication 7 is
indicated after warming up the printer.
1. Print the status page. (See page 1-4-2.)
2. Print the status page to check that the
firmware version has been updated.
Figure 1-7-9
To PC
Parallel
printer cable
>Copy /b dm9602.spa prn
1
2
3
4
5
6
7
Ready
Ready
Message display
PC DOS display
Supervisor mode
parallel waiting
Downloading
>echo !R! BOOT'SPR';exit;>PRN
Power switch: Off/On
Version 04
Language
Release date
Check sum
Spanish 04
02/06/07[1234]
Figure 1-7-10
Connecting the parallel printer cable
Checking the update
Downloading the message data file
To Next Page
Loading...
