FS-6020
1-6-21
(3) Detaching and refitting the heat roller
Perform the following procedure when the heat roller is to be checked or replaced.
Procedure
1. Remove the fixing unit (see page 1-6-18).
2. Remove the fixing heater lamp.
3. Pull the left and right heat roller bushes up
and then remove the heat roller.
4. Remove the heat roller gear Z36 and left and
right heat roller bushes from the heat roller.
5. Check or replace the heat roller.
6. Refit all the removed parts.
Figure 1-6-25
Heat roller
Heat roller gear Z36
Left heat roller bush
Right heat roller bush
To Next Page
Loading...
