Kyocera FS-6020 - Installing Expansion Memory (Optional)

FS-6020
1-3-8
1-3-2 Installing expansion memory (optional)
Procedure
1. Turn off the printer power switch.
Cautions
Do not insert or remove expansion memory
while the printer power is on. Doing so may
cause damage to the printer or the expansion
memory.
2. Remove one screw and then remove the
optional interface slot cover.
3. Open the stoppers of the memory socket.
4. Insert the memory so that the two notches of
the memory are engaged with the projections
of the memory socket.
* Memory produced by Melco Inc. of which
the operation has been confirmed is
recommended.
5. Close the stoppers of the memory socket.
6. Reattach the optional interface slot cover to
its original position.
7. Print a status page to check the memory
expansion.
* If memory expansion has been properly
performed, information on the installed
memory is printed and the total memory
capacity has been increased.
(Memory capacity at shipping is 16 MB.)
Figure 1-3-11
Figure 1-3-12
Screw
Optional interface
slot cover
Stopper
Memory
Memory socket
Stopper
Capacity Part number
16 MB PM-HP-16M-KC
32 MB PM-HP-32M-KC
64 MB PM-HP-64M-KC
128 MB PM-HP-128M-KC
Produced by Melco Inc.
Recommended memory
(Operation has been checked.)