1-3-7
FS-6020
Printing a status page for test.
1.Turn on the printer power switch. Initialization of
the machine will start. The message will change
from “Self test” to “Please Wait Adding
toner” and then change to “Ready” when
initialization is complete (after approximately 15
minutes).
2.Use the following key operation to print a status
page for test.
1 Press the MENU key when “Ready” is
displayed.
2 Press the N key to display “Print Status
Page”.
3 Press the ENTER key to display “Print
Status Page?”.
4 Press the ENTER key. “Processing” will be
displayed and status page printing will start.
When printing is complete, “Ready” will appear
again.
3.Check to see if the printout of the status page is
proper.
Completion of the machine installation.
To Next Page
Loading...
