FS-6020
1-6-15
1-6-4 Laser scanner unit section
(1) Detaching and refitting the laser scanner unit
Perform the following procedure when the laser scanner unit is to be checked or replaced.
Procedure
1. Remove the top cover (see page 1-6-2).
2. Remove the right cover (see page 1-6-4).
3. Remove the two connectors from the main
PWB and one connector from the laser
scanner unit.
4. Remove the four screws and then remove the
laser scanner unit.
5. Replace or check the laser scanner unit.
6. Refit all the removed parts.
Figure 1-6-18
Screws
Laser scanner unit
Connector
Connectors
YC11
YC8
To Next Page
Loading...
