FS-6020
1-6-14
(6) Detaching and refitting the drive assembly
Perform the following procedure when the drive assembly is to be checked or replaced.
Procedure
1. Remove the three hooks of ground springs.
2. Remove the feed clutch and middle feed
clutch.
Figure 1-6-16
3. Remove the four connectors from the main
PWB and one connector from the main motor.
4. Remove the four screws and then the drive
assembly.
5. Replace or check the drive assembly.
6. Refit all the removed parts.
Figure 1-6-17
Feed clutch
Middle feed clutch
Ground springs
Ground spring
Connectors
Screws
Drive assembly
Screws
Connector
To Next Page
Loading...
