Kyocera FS-6970DN - Detaching and Refitting the Engine PWB

2J5
1-5-23
1-5-8 PWBs
(1) Detaching and refitting the engine PWB
Procedure
1. Remove the developer unit (See page P.1-5-
11).
2. Remove the drum unit (See page P.1-5-12).
3. Remove the top cover (See page P.1-5-3).
4. Remove the left cover (See page P.1-5-4).
5. Remove the PSU fan motor (See page P.1-
5-29).
6. Stand the printer front side up.
7. Remove five screws and then remove the
bottom plate 1.
8. Remove four screws and then remove the
bottom plate 2.
Figure 1-5-32
9. Remove two wires from the hooks and
notches.
10. Open the DU guide (duplex cover).
Figure 1-5-33
Screw
Screw
Bottom plate 1
Bottom plate 2
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Wire
Hook
Notch
DU guide (duplex cover)