Kyocera KM-2540 - Relay Board Maintenance; Setting of Deflection for Feeding from DP; Checking the Developing Unit Number

2JB/2JC
1-3-68
U935
Relay board maintenance
Description
Sets the mode when call for service (C0060) occurs.
Purpose
Sets the machine status temporarily when call for service (C0060) occurs. However, after the setting, call for
service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select the item.
Initial setting: 0
3. Press the start key. The setting is set.
4. Turn the main power switch off and on.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
U942
Setting of deflection for feeding from DP
Description
Adjusts the deflection generated when the optional DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Setting
1. Press the start key.
2. Select the item to be adjusted.
3. Press the interrupt key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the interrupt key.
6. Change the setting value using the cursor up/down keys.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
7. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U984
Checking the developing unit number
Description
Displays the developing unit number.
Purpose
To check the developing unit number.
Method
Press the start key. The number is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description
MODE 0 Setting mode: OFF
MODE 1 Setting mode: ON (Usable up to three times of use)
Display Description Setting
range
Initial
setting
Change in
value per step
FEED MOT Deflection in the original feed motor -31 to 31 0 0.098 mm
REV MOT Deflection in the original switchback
motor
-31 to 31 0 0.098 mm