Kyocera KM-2540 - Page 266

2JB/2JC
2-3-20
YC4 1 N.C. - - Not used
Connected
to the left
operation
unit PWB
2SGND -- Ground
3 DIG_LED_5 O 0/5 V DC (pulse) Operation panel indicator LED drive signal 5
4 DIG_LED_4 O 0/5 V DC (pulse) Operation panel indicator LED drive signal 4
5 DIG_LED_3 O 0/5 V DC (pulse) Operation panel indicator LED drive signal 3
6 SCAN8 O 0/5 V DC (pulse) Scan signal 8
7 SCAN7 O 0/5 V DC (pulse) Scan signal 7
8 SCAN6 O 0/5 V DC (pulse) Scan signal 6
9 SCAN5 O 0/5 V DC (pulse) Scan signal 5
10 DIG_KEY_7 O 0/5 V DC (pulse) Operation panel key scan return signal 7
11 X1 O Analog Touch panel X1 position signal
12 Y1 O Analog Touch panel Y1 position signal
13 X2 O Analog Touch panel X2 position signal
14 Y2 O Analog Touch panel Y2 position signal
Connector Pin No. Signal I/O Voltage Description