2JN-2
1-3-3
Operation
panel and
support
equipment
U200 Turning all LEDs on -
U203 Checking DP operation -
U207 Checking the operation panel keys -
U222 Setting the IC card type -
U223 Operation panel lock -
U243 Checking the operation of the DP motor solenoids and clutch -
U244 Checking the DP sensors -
Mode setting U250 Setting the maintenance cycle 100000
*1
U251 Checking/clearing the maintenance count -
U252 Setting the destination -
U253 Switching between double and single counts Double count
U260 Selecting the timing for copy counting EJECT
*1
U265 Setting OEM purchaser code 0
U278 Setting the delivery date -
U285 Setting service status page ON
U332 Setting the size conversion factor 1.0
*1
U342 Setting the ejection restriction ON
*1
U343 Switching between duplex/simplex copy mode OFF
*1
U345 Setting the value for maintenance due indication 0
*1
Image
processing
U402 Adjusting margins of image printing 30/25/25/50/50
U403 Adjusting margins for scanning an original on the platen 2.0/2.0/2.0/5.0
U404 Adjusting margins for scanning an original from the DP 3.0/2.5/3.0/4.0
U407 Adjusting the leading edge registration for memory image printing 0
U411 Adjusting the scanner automatically -
U425 Setting the target -
Fax U600 Initializing all data -
U601 Initializing permanent data -
U603 Setting user data 1 DTMF
*2
U604 Setting user data 2 2 (120 V)
*2
1 (220-240 V)
*2
U605 Clearing data -
U610 Setting system 1
Setting the number of lines to be ignored when receiving a fax at
100% magnification
Setting the number of lines to be ignored when receiving a fax in
the auto reduction mode
Setting the number of lines to be ignored when receiving a fax
(A4R/LetterR) in the auto reduction mode
3
0
0
U611 Setting system 2
Setting the number of adjustment lines for automatic reduction
Setting the number of adjustment lines for automatic reduction
when A4 paper is set
Setting the number of adjustment lines for automatic reduction
when letter size paper is set
7
22
26
Section Item
No.
Content of maintenance item Initial
setting*
*: Factory initial setting, *1: The item initialized for executing U021, *2: The item initialized for executing U600
To Next Page
Loading...
Need help?
General
