EasyManuals Logo

Kyocera Mita FS-1128MFP Service Manual

Kyocera Mita FS-1128MFP
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
2JN
1-3-59
U641
Setting communication time 2
Description
Sets the time-out time for fax transmission.
Purpose
To improve transmission performance for international communications mainly.
Start
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
Setting the T0 time-out time
Sets the time before detecting a CED or DIS signal after a dialing signal is sent.
Depending on the quality of the exchange, or when the auto select function is selected at the destination unit,
a line can be disconnected. Change the setting to prevent this problem.
1. Change the setting using the cursor left/right keys.
2. Press the start key. The value is set.
Setting the T1 time-out time
Sets the time before receiving the correct signal after call reception. No change is necessary for this mainte-
nance item.
1. Change the setting using the cursor left/right keys.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the T2 time-out time
The T2 time-out time decides the following.
From CFR signal output to image data reception
From image data reception to the next signal reception
In ECM, from RNR signal detection to the next signal reception
1. Change the setting using the cursor left/right keys.
2. Press the start key. The value is set.
Maintenance
item No.
Description
Display Description
T0 TIME OUT Sets the T0 time-out time.
T1 TIME OUT Sets the T1 time-out time.
T2 TIME OUT Sets the T2 time-out time.
Ta TIME OUT Sets the Ta time-out time.
Tb1 TIME OUT Sets the Tb1 time-out time.
Tb2 TIME OUT Sets the Tb2 time-out time.
Tc TIME OUT Sets the Tc time-out time.
Td TIME OUT Sets the Td time-out time.
Description Setting range Initial setting
T0 time-out time 30 to 90 s 56
Description Setting range Initial setting
T1 time-out time 30 to 90 s 36
Description Setting range Initial setting Change in value per step
T2 time-out time 1 to 255 69 100 ms

Table of Contents

Other manuals for Kyocera Mita FS-1128MFP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera Mita FS-1128MFP and is the answer not in the manual?

Kyocera Mita FS-1128MFP Specifications

General IconGeneral
Print TechnologyLaser
Print Resolution1200 x 1200 dpi
Copy Resolution600 x 600 dpi
Scan Resolution600 x 600 dpi
Duplex PrintingYes
ConnectivityUSB 2.0, Ethernet
Monthly Duty Cycle20, 000 pages
FunctionsPrint, Copy, Scan, Fax
Fax Transmission Speed33.6 Kbps
Print Speed28 ppm
Copy Speed28 cpm
Standard Paper Capacity250 sheets
Automatic Document Feeder (ADF)50 sheets

Related product manuals