LaCie Ethernet Disk RAID (Firmware version 1.4)
User Manual
page 44
Managing Your Ethernet Disk RAID
To change this Do this
e IP address of the primary
Active Directory server
In the Primary server IP address text box, enter the IP address of your primary Ac-
tive Directory server. (You cannot use the server’s name.)
NOTe: e new server must reside in the same domain as the original server. To
change domains, you must change the authentication mode (see section 5.4.5.1,
Changing Authentication Mode).
e IP address of the secondary
Active Directory server
In the Secondary server IP address text box, enter the IP address of your secondary
Active Directory server. (You cannot use the server’s name.)
NOTe: e secondary server must reside in the same domain
as the primary server.
e user name or password for
browsing the Active Directory
tree
In the User name text box, enter the name of a user who has privileges to access the
Active Directory tree.
In the Password text box, enter the password associated with that user name.
is user name and password will be used to obtain new user and group information
from the Active Directory server at every synchronization.
Make the desired changes, if any, and click Apply:3.
To immediately synchronize the storage system and
the Active Directory server, click Synchronize Now.
4.
TeChNICAl NOTe: If the clocks of the stor-
age system and the Active Directory server differ
by more than five minutes, errors will occur when
the two systems synchronize. It is recommended
that you configure both the storage system and
the Active Directory server to set their clocks
from a common Network Time Protocol (NTP)
server.
To Next Page
Loading...
