LaCie Ethernet Disk RAID (Firmware version 1.4)
User Manual
page 84
Protecting Local Disks
4. On the first page of the installation wizard, click
Next.
5. On the page with installation options, click Next.
(Initiator Service and Software Initiator are selected
by default.)
6. If a message box appears telling you to configure the
settings in the Control Panel, click OK.
7. If you agree to the terms of the license agreement,
select I Agree and then click Next.
8. When the installation completes, click Finish. Af-
ter your computer restarts, you can install Windows
Backup Software.
TeChNICAl NOTe: You do not have to con-
figure the Microsoft iSCSI Initiator. Windows
Backup Software will configure it for you auto-
matically.
7.1.4. Installing Windows Backup Software■
You must install Windows Backup Software on
each computer whose local disks you want to protect.
A single license for the Ethernet Disk RAID is located
on the back of the unit. Additional licenses can be pur-
chased from http://www.intel.com/design/servers/stor-
age/offers.
To install Windows Backup Software
Log on as an administrator and insert the installation
CD into a CD-ROM drive.
Select Applications from the top menu.
Select the “Windows Backup Software” link to in-
stall the software.
Start the setup utility for Windows Backup Soft-
ware.
1.
2.
3.
4.
If the Microsoft* iSCSI Initiator 2.0 is already in-
stalled, go to the next step. If this component is not
currently installed, the prompt in Fig. 7.1.4.B ap-
pears.
5.
Fig. 7.1.4.B
To Next Page
Loading...
