Lamtec F300K Series - Save Parameters (down Load)

70
7 Operation
NOTICE
The active operating mode parameters* for the switch-on and switch-off operation are reset to
the LAMTEC factory settings in the flame scanner for the current safety time.
This involves a precision setting for the detection of the flame and is a good way to start when
putting the flame scanner into operation.
* Operating mode parameters = learned or manually set parameters for the operation of the
F300K
7.5.4 Save parameters (down load)
NOTICE
The device parameters that currently exist in the flame scanner and all of the operating mode
parameters are copied to the level of the operating unit.
 Flame scanner parameters at the level of the operating unit are overwritten without a re-
quest for confirmation.
Saving device and operating parameters at the level of the operating unit
The data has been successfully saved.