92
10 Correcting Faults
* W = warning is generated
10.2 Information About the Repair Service
Please contact LAMTEC Service/Support if you have any questions.
Different amplification double sensor,
Flame ON and flame OFF with different distances of amplificationsrecorded. Learn
flames data again
L1011 Analysis - X
Different weighting double sensor,
Flame ON and flame OFF with different weighting of signal recording. Learn flames
data again
Learning function errors
Parameter transfer errors
No. Description Graphic W *
E200X Communication -
Repeat the operation. If this does not eliminate the error, the device is defective.
E2012 Communication -
PW error, PW Level 1 and 2 have been entered equal
E300X Communication -
Repeat the operation. If this does not eliminate the error, the device is defective.
E400X Communication --
Repeat the operation. If this does not eliminate the error, the device is defective.
E5001 Communication --
Parameters from other F300K.
E5002 Communication --
No data transmission possible, since the stored data does not belong to the current
F300K.
W
LAMTEC GmbH & Co.KG
Sensors and Systems for Combustion
Technology
Wiesenstraße 6
D-69190 Walldorf
Hotline: +49 (0) 6227 / 6052-33
email: support@lamtec.de
To Next Page
Loading...