EasyManuals Logo

Lamtec F300K Series User Manual

Lamtec F300K Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
91
10 Correcting Faults
Two F300K Remote Software programmes have been detected on the bus.
Remove one of the F300K Remote Software programmes from the bus or close it.
C0012 Unknown device --
Data is received from a device with an unknown device ID.
UI or F300K Remote Software is too old. Update the software.
C0012
C0013 Excess temperature display - -
Display switched off because of excess temperature. Communication is not affected. - -
Communication error
Learning function errors
No. Description Graphic W *
L1000 Analysis -
Desired functionality is not yet supported.
X
L1002 Analysis
No valid learning data:
Error during recording:
- Not ready for operation
- Periodicity
- Overload
L1003 Analysis --
No "flame ON" data.
No "flame ON" data learned/recorded.
L1005 Analysis - X
Data obtained cannot be used,
Amplitude at "flame on" < amplitude at "flame OFF" (process reliability < 1).
"Flame ON" and "flame OFF" mixed up during learning.
Selected frequency is too high, it can not find a suitable trigger threshold
Note:
Flame scanner testing Device FFP30 does not contain sufficient frequency
components above 100Hz.
Plant requires this state.
L1006 Analysis - X
Distance of threshold/level from the limit level too short (process reliability < 1)
Flame with small differences from the background radiation
Unfavourable frequency and/or other parameters selected.
L1007 Analysis - X
From F300K SW-Version 1.1 onwards, the evaluation is based on the current present fre-
quency band "S" or "T".
If this is modified after the compilation of the learning data, an evaluation would not be
possible. Reset the frequency band or re-evaluate.
L1008 Analysis - X
No evaluable data
Data is not compatible with the SW F300K, learn flames data again.
L1009 Analysis - X
Serial number different
Data is not compatible with the SW F300K, learn flames data again.
L1010 Analysis - X

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lamtec F300K Series and is the answer not in the manual?

Lamtec F300K Series Specifications

General IconGeneral
BrandLamtec
ModelF300K Series
CategoryScanner
LanguageEnglish